If you’ve decided that a sump pump is necessary for your home, you may be wondering how to install it yourself. Before you start, it’s important to understand the steps involved in installing this important appliance. For example, you’ll need to attach a Float switch and a check valve, which are required components of the sump pump. Then you can follow the steps outlined in this article to install your Float switch and Check valve.
Installation Of A Sump Pump
Installing a sump pump is easy if you follow the instructions carefully. Most pits are covered, but you can make a hole in the bottom of the basin for drainage. Then, you can place fabric filters around the basin to prevent sediment from entering the basin. Once the filter is in place, lay a gravel base on top of it and add rough stones or paving stones to create a firm platform. Once the gravel base is level, install the sump pump in the hole and fill in the basin with excavated soil.
If you do not install a sump pump, it may fail to work. Some of the reasons why a sump pump fails include: inappropriate construction material, incorrect installation, continuous cycling, and stuck switches. Nevertheless, the average lifespan of a sump pump is seven to 10 years. It is therefore important to install a sump pump at your home when the weather is favorable. You should also ensure that the pump is properly maintained for its life expectancy.
Installation Process
If you’re having trouble with the moisture in your basement, you may be wondering how to install a sump pump yourself. The process is simple, but it’s important to make sure you’re properly prepared. After all, the installation technician will need to work in an area of your basement where he can access the basement’s drain and discharge water. Fortunately, there are several things you can do to help ensure the installation goes as smoothly as possible.
First, you’ll need to dig a drainage hole to install a sump pump. In some cases, this can be an area where water is already flowing, or may be a French drain system. Either way, the area you’re directing water to will trigger a float switch in the sump pump. The pump will then turn on and remove water from the pit. The pump may be submerged in the pit or mounted on a pedestal outside of it.
Check Valve Installation
Before you begin checking out the installation procedure of a new check valve, you must make sure you have the correct pipe length for the sump pump. The closer the valve is to the sump pump, the less water can accumulate around it. Using a hose clamp, measure from the middle of the two sets. You may use a pipe cutter to make the pipes slightly softer, but you should be sure to use pliers for safety.
After you have determined the location for the check valve, cut the pipe at two points. The check valve will go in between these two points. Use a pipe cutter to cut the pipe at the right places, and then trim the edges with a metal file. Once you’ve completed this step, you can begin installing your check valve. Don’t rush through this process. It may take some time, so be patient.
Float Switch Installation
Float switch installation for a sump pump requires a little more knowledge than installing a new faucet or sink faucet. First, find the switch. It will be located on the pump housing. Remove the old switch and then carefully unscrew the cap. Glue in the replacement switch and allow it to dry. Seal the float switch properly to prevent water from entering the pump and clogging it.
The float switch should be able to accommodate the voltage and amperage that your pump draws. Most float switches are 110-120V, while most electronic controllers run at 220-240V and draw from 10 to 15 amps. Make sure the voltage and amperage of your pump falls within these ranges. Otherwise, the pump may malfunction and you will have to replace the float switch. This simple maintenance process is inexpensive and will give you peace of mind.
